Creality CR-X 12864 LCD Conversion/Upgrade Kit

• All the parts to add a 12864 LCD to your CR-X with NO soldering at all.
  • LCD Housing (in PLA or ABS, select above)
  • Screws for the 12864 LCD (M3 x 8mm, 5 total)
  • TH3D 12864 LCD
    • Note: SD slot on LCD is not used, the SD slot on the printer board is what you will still use
  • Cables for the 12864 LCD
  • Knob for the LCD Encoder
• Simple setup and firmware update included in our Unified Firmware to support the new LCD
• Get all the features you are missing out on with the Touch Screen
  • Babystepping Z (Live Z Adjustment)
  • Full ABL Probe Offset and other settings
  • EStep Settings
  • Acceleration/Jerk Settings
  • Firmware has Thermal Runaway Protection

Will this work with Klipper? Yes, these LCDs and the stock board are supported by Klipper firmware. However, due to the complexity of Klipper, our technical support that is included does NOT apply if you are using Klipper firmware. Technical support only applies when you are using our Unified 2 Firmware package that is included.

Warranty Information

3 Months Warranty -  Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link. Technical support is limited to the scope of the product itself and not your entire machine.

Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.