Delrin V Slot Wheel – 5mm Bolt Hole (10 Pack)
$22.46
Wheels on your 3D printer wearing out? We have high quality replacement wheels!
Replacement wheel with bearings – Outer Delrin wheel shell with 2x bearings & alignment spacer pre-assembled
Works with most 3D printers that use v slot wheels
Check pictures for dimensions to compare to yours
Check below for brand/printer models guaranteed to fit
Each item qty is for 10 wheels. Less than 10? Get our 2 pack here.
Works on any axis that has wheels on your printer. See below for the compatibility list. If you don’t see your printer listed you can contact us with pictures or a link to your machine and we can double check for you.
Specifications
Printer Compatibility
- Creality
- Ender 2/3/4/5/6
- CR-6 Series
- CR-10 All Sizes
- CR-10S All Sizes
- CR-10S Pro
- CR-10 V2/V3
- CR-20/CR-20 Pro
- CR-X
- Alfawise
- U10
- U20
- Geeetech
- A10 V1 (model with no filament sensor)
- A30
- Tevo
- Tornado
- Flash
- Michelangelo
- Other
- Sidewinder X1
- Sovol SV01/SV02/SV03
- Voxelab Aquila
- Any Machine that uses V slot wheels that match the measurements shown above.
- Not listed here? Contact us to verify fitment.
Warranty Information
3 Months Warranty - Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link. Technical support is limited to the scope of the product itself and not your entire machine.
Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.
Share your thoughts!
Let us know what you think...
What others are saying
Related products
Daniel Linthicum (verified owner) –
If you have multiple printers using V slot, this is a great deal from a reputable company. Great to have a bunch of spares on hand. Bearings feel great and the wheels are of the same quality on the surface as the stock Creality wheels. Good deal!
(0) (0) Watch Unwatch
Question
Ask Tegler (verified owner) –
I recently bought this for my Ender 6 and wondered how do I change it on the printer head?
Do I have to disassemble everything?
And how can I make sure everything is level?
(0) (0) Watch Unwatch
Tim Hoogland –
You just need to unbolt the existing wheel and remove anything that impedes access to the nuts and/or bolts. Remove the stock wheel, then install the new one. Reassemble whatever was removed in the reverse order that you removed it from the carriage in.
(0) (0)