24V 350W PSU Replacement/Upgrade – Genuine MeanWell

• Anet A8 Plus
• Ender 3
• Ender 3 Pro
• Ender 3 S1
• Ender 3 S1 Pro
• Ender 3 S1 Plus
• Ender 4
• Ender 5
• Ender 5 Pro
• Ender 3 V2
• Ender 6
• Ender 7
• Creality CR-6
• Geeetech A10
• Geeetech A10M
• Geeetech A20
• Geeetech A20M
• Sovol SV01
• Sovol SV03
• Sovol SV06
• May fit other models. Contact us with a picture of your PSU to verify fitment.
  • Most stock PSUs will list 24V 15A on them. This will replace most of those.

Ender 5 Plus: This does NOT fit the Ender 5 PLUS, If you have the 5 Plus you want the 450W PSU we carry.

---

CHECK POWER SWITCH BEFORE INSTALLING. - SET TO YOUR COUNTRY VOLTAGE (115 for US/Canada - 230 for Most other places)

• Output: 24 VDC @ 350 W 14.6A
• Input Voltage - 100-120VAC, 200-240VAC

NOTE: MeanWell has adjusted the fan tuning curve on newer power supplies. The fan in the power supply now turns on later than previous revisions, generally around 6-8 minutes under full load. This may result in the fan not turning on immediately during printing, but should eventually kick on under sustained load when needed.

Warranty Information

3 Months Warranty -  Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link.

Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.