TH3D 5015 High Speed Dual Ball Bearing Fan V2 (24V)

Compatible Machines:

• Tevo Tornado
  • Layer Fan – For use with aftermarket mounts like PETSFang
• Geeetech A10
  • Layer Fan – For use with aftermarket mounts like PETSFang
• Ender 3/Ender 3 Pro/Ender 5/Ender 5 Pro/Ender 5 Plus
  • Layer Fan – For use with aftermarket mounts like PETSFang
• Tevo Tarantula Pro
  • Layer Fan – For use with aftermarket mounts like PETSFang
• CR-10S Pro
  • Layer Fan – For use with aftermarket mounts like PETSFang
• Other 24V Printers
  • Layer Fan – For use with aftermarket mounts like PETSFang

Installation Notes:

• Be sure to check the polarity on the wires you are connecting our fans to. Typically red is positive and black/blue is negative but some of the Chinese printers to not adhere to these standards.
  • There is no list of what machines use what as it can vary from model to model and we have even seen differences in wiring colors used in the same printer models.
• Our fans use red for positive and black(or blue) for negative. You can verify polarity with a cheap $10 multimeter from Amazon or you local hardware store.
  • If fans are shorted out/killed due to improper wiring this is NOT covered under warranty.

Tech Specs

• 5015 Blower Fan
• Great for Layer Fan Use
• New V2 Fans work without capacitors or the “FAN_FIX” option in firmware
• 24V up to 0.1A power Draw
• DUAL Ball Bearing for 50K+ Hours of runtime
• CFM Rating: 5 CFM
• RPM: 5200 RPM
• Noise: 37dBA Noise
• 3″ Red/Black Power Lead with 2 Pin JST Plug
• 90 Day Warranty
• Wire Length: 3″
• 2 “UY” quick connectors for solder-free installation
  • See picture below for how to use. Use WIDE pliers and apply equal force.
  • Make sure wires are straight and centered in the connector before squeezing.