TH3D 60mm Fan (24V) – Dual Ball Bearing
$9.99
- Direct replacement for PSU fan
- Dual Ball Bearing for long life
- Longer life than stock fans
- Solder-free connectors included
- Tech specs are below
In stock
- Be sure to check the polarity on the wires you are connecting our fans to. Typically red is positive and black is negative but some of the Chinese printers do not adhere to these standards.
- There is no list of what machines use what as it can vary from model to model and we have even seen differences in wiring colors used in the same printer models.
- Our fans use red for positive and black for negative. You can verify polarity with a cheap $10 multimeter from Amazon or you local hardware store.
- If fans are shorted out/killed due to improper wiring this is NOT covered under warranty.
- If you want to reduce your PSU fan noise you can print this part that ducts the air to reduce noise: https://www.thingiverse.com/thing:3345042
- Voltage: 24V DC @ 0.1A
- Airflow: 25 CFM
- Noise: 32 dBA
- RPM: 4500
- Bearing: Dual Ball
- Wire leads: 2 wire
- Life Rating: 60,000 hours (6+ years)
Part Fitment/Installation
This is a universal 3D printer part. That means it will work on almost any 3D printer (check your printer voltage and part voltage) with the correct mount for your specific machine. Thingiverse is a wonderful place to locate mounts and we also have printed parts in our shop for some universal parts.
It is up to you to determine and select a mount for your specific printer model (or design one) to install this part on your machine and wire it up to your machine (if applicable). You are welcome to Contact Us for recommendations for your particular printer model for mounting options that are available online if searching yourself does not yield any results.
| Weight | 3 oz |
|---|---|
| Dimensions | 2 × 2 × 1 in |
| Made In | 🇨🇳 China |
| Warranty Length | 6 Months |
Q & A
Ask a question
Your question will be answered by a store representative or other customers.
Thank you for the question!
Your question has been received and will be answered soon. Please do not submit the same question again.
Error
An error occurred when saving your question. Please report it to the website administrator. Additional information:
Add an answer
Thank you for the answer!
Your answer has been received and will be published soon. Please do not submit the same answer again.
Error
An error occurred when saving your answer. Please report it to the website administrator. Additional information:
Related products
This fan works for both the main board cooling fan and the hot end cooling fan (not the part cooling fan). They run smoother and quieter than the stock fans and will last much longer.
I figured I’d try swapping this PSU fan for the one on my Ender 3 after swapping the other two (hot end and controller). This is a definitely a much better quality fan than the one in the stock Ender 3 power supply. I’m not sure if it’s any quieter than the stock fan, but it wasn’t any louder… And it definitely seems to push a lot more air. I decided to try a fan shroud (off thingiverse) which seemed to help with noise levels (part of the motivation to replace them). I might have been concerned using it with the stock fan for airflow, but no worries with this one.
The only issue I had was with the Stock Ender 3 PSU and not the fan. When I pulled the stock fan connector the stupid glue pulled the whole connector off and I wasn’t 100% of the orientation of it on the power supply board. I went by what they had printed on the circuit board (+/-) for the connector and put everything back together. The fan didn’t work. It turned out it the print on the circuit board was wrong (Verified with my multimeter). I flipped the connector back around, powered it on, and everything was good. The fan works great and will probably outlast the rest of the power supply.