EZABL – Setup for “Vanilla” Marlin

PLEASE NOTE: If you have a printer with the stock board the easiest and quickest setup is to use our Unified Firmware package. This guide is for people using the EZABL with a non-supported printer/board and/or those that want to use “Vanilla” Marlin with...

EZABL – Tevo Tarantula Pro Z Endstop Cable

The Tevo Tarantula Pro uses a 3 pin endstop switch on all axis. These carry the Signal, 5V, and GND lines. The 5V line is there to light up the status LED on the endstop boards. This however is not needed and must be removed before connecting the EZABL control board...

Tips for EZABL accuracy

The ‘spring’ type Z-motor couplers allow vertical play, which can affect the probe results. You can replace them with ‘Plum’ style couplers which have no vertical movement. TH3D Shop link:...

Geeetech A10, A10M, A20, A20M Z Endstop Wiring for EZABL

The Geeetech Endstop switches have a 5V line run to them to drive the LED when the switch is activated. When using the 3 pin JST endstop connection on our EZABL boards you will need to remove the 5V line so you don’t accidentally short it to ground. The switch...

Using the EZABL with CR-10S Printers with Touch LCD

The CR-10S with the touch will work with the EZABL however there are a few differences with the setup. Since the touch LCD does NOT support setting the Z offset or Babystepping you cannot do it without a computer. EEPROM: To reset the EEPROM send M502 followed by M500...