Storing Bed Leveling Mesh & Updating Your Slicer

The EZABL and the Unified Firmware support storing your bed leveling mesh. What this means is that you only need to probe the bed initially and then you can store it so all that is needed in your starting code is G28 then M420 S1 to recall the mesh data from EEPROM. ...

Direct Wire 12V/24V Power Info

See below for a wiring output from the CR-10 Power Supply. We recommend getting power from here. This is also applicable for MOST 12V/24V power supplies with the same connections. This is a 12V 30A PSU shown below. 24V PSUs are the same layout typically. When in doubt...

Advanced EZABL and Printer Troubleshooting

Is the bed level-ish? EZABL™ can’t work miracles. You need to make sure your bed is as level as you can get it by adjusting the corner screws. When you have EZABL™ working well you may like to consider swapping the springs and screws for solid mounts. You can...

Z Not Showing “TRIGGERED” M119 Test

THIS ALSO APPLIES TO THE DIRECT WIRE. JUST SWAP THE 2 WIRES AND RUN THE M119 TEST AGAIN.  If you are getting a reversed TRIGGERED/open then you need to set up the firmware correctly per the directions at the top of the Configuration.h file. Issue  If your Z Endstop is...

Z Axis Troubleshooting

Details After sending out multiple kits and getting feedback from customers that have issues there are many that had Z axes that were not working correctly and this throws off the probe. Before you move forward to check that you can easily move your Z axis leadscrews....