60mm Vapo™ Bearing Fan (12V) – Quiet (30dBA)
$11.99
- Direct replacement for PSU fan
- Genuine Vapo-Bearing™ fans
- Quieter than stock fans and MUCH longer life
- Solder-free connectors included
- Tech specs are below
Available on backorder
Product Info
Compatible Machines:
- CR-10 and CR-10S – ALL Sizes
- PSU Fan
- Ender 2
- PSU Fan
- Alfawise U10
- PSU Fan
- Ender 3/4/5
- PSU Fan
- SOME have 12V fans, verify before purchase by opening up PSU and checking fan voltage on its label (others have 24V which we sell here)
Installation Notes:
- Be sure to check the polarity on the wires you are connecting our fans to. Typically red is positive and black is negative but some of the Chinese printers to not adhere to these standards.
- There is no list of what machines use what as it can vary from model to model and we have even seen differences in wiring colors used in the same printer models.
- Our fans use red for positive and black for negative. You can verify polarity with a cheap $10 multimeter from Amazon or you local hardware store.
- If fans are shorted out/killed due to improper wiring this is NOT covered under warranty.
Tech Specs:
- Airflow: 16-18 CFM
- Static Pressure: 0.12-0.14 in H2O
- Noise: 28-30 dB(A) – stock fans are 40-50 dB(A)
- Voltage: 12V DC
- Bearing Type: Vapo-Bearing™
- Size: 60x60x15MM
- RPM: 3800-4000
- Wire Length: 10″
- 2 “UY” quick connectors for solder-free installation
- See picture below for how to use. Use WIDE pliers and apply equal force.
- Make sure wires are straight and centered in the connector before squeezing.
- Product picture may vary. Specs are listed above.
Support/Warranty
- Included Support: TH3D Community Support
- Warranty: 90 Days
bktransactions (verified owner) –
Replacing the stock fans with this fan coupled with the other two really reduced the fan noise from my CR-10 control box which was really annoying. I recommend buying the kit of three and saving some $.
(0) (0) Watch Unwatch
Joshua Cass (verified owner) –
My Ender 3 Pro had a 12v PSU fan (check your own fan to verify, it’s written on the fan), and this replacement made a huge, huge difference in noise levels. Two other 24v 40mm fans from this site also helped make my printer is much, much quieter. It no longer sounds like a turbo jet prepping for take-off. I sometimes think the print’s done early, but nope, it’s still silently chugging along.
Other sound upgrades I’ve made (not on this site) include a 5015 part cooling fan and the v1.1.5 silent mother board with TMC2208 drivers.
Thanks for the high quality parts. Oh, and the nerds!
(0) (0) Watch Unwatch