Ender 5 Plus/Ender 6 EZABL Z Signal Cable

You do NOT need this cable to connect the EZABL to the Ender 5 Plus or Ender 6 unless you do not want to cut your stock wires. This cable offers a plug and play setup with no cutting of the stock wires.

You will only need this cable if you do not want to cut the black/white wire (2 pin plug on the end) that goes to the stock BL Touch to use with our EZABL Board.

Warranty Information

3 Months Warranty -  Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link.

Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.