EZNeo – EZBoard V2.X Board Setup

What you will need The EZNeo Strip Plug it in! The EZBoard V2 board has a dedicated NeoPixel header. This pin is pre-setup in our firmware and Marlin 2.0. Just simply plug in the EZNeo cable to the NeoPixel header on the board as shown below and the other end of the cable into the […]

EZBoard V2.X Board Firmware

Do you have our EZBoard V2 and are looking to compile firmware on your local computer? If you don’t require special configurations or want to setup VSCode you can always use our EZFirmware website to compile for you free of charge to all EZBoard customers. This firmware supports all printers that the EZBoard Lite supports. What printers are supported? […]

EZBoard V2 – Installation Guide

Getting Started Welcome to the TH3D EZBoard V2 Documentation! Almost everything is plug-and-play. Make sure to unplug your printer from the wall before installing this or any other parts on your printer. We will cover the connections on the board and then go over adding things like filament sensors, EZABL, and BL Touch, all optional […]